![]() Take a damp rag and use it to remove any sand dust from the top and interior of your coffee table. When the wood filler is dry, sand the surface once again. If you notice any miter joint gaps, you can use wood filler on those as well. Step Three: Filling the woodĪs you remove the nails from the corners of the table, you will need to fill the holes using wood filler. Nails are mostly used as placeholders, as the glue will do most of the bonding.įor the best results, attach the two small sides to a large one, allow the glue to dry, and then come back and attach the second large piece so that you form a rectangle with all the four pieces. You can use nails or screws to hold the pieces together, but you need to make sure that they are correctly placed next to one another, creating 90-degree angles. Make sure you put wood glue on both pieces of the miter joint and use clamps to hold all the pieces together. You want to use quality wood glue here and apply it on the edges of the wooden pieces, right on the 45-degree cuts. Make sure to sand the surfaces when you’re done. What you’re basically looking to make here is two wood pieces for the top and bottom side of the table, plus two smaller ones that serve as sides. You also want to set up a jig on the table saw to cut at 45-degree angles. Adjust the table saw and flip the board to make one final cut to ensure you have straight edges on both sides. Cut one piece on each side to make sure the pieces are of the same width. ![]() Cut the pieces of wood on your table saw.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |